Fuzzbuster Installation

If you would like to improve on the installation of your Fuzzbuster, try this. Don’t waste your money on the $5 bracket Fuzzbuster sells, but opt for the $12 one, with suction cups. Put the suction cups on the arm which swings, stick them to the window in the center of the dash, drill a quarter-inch hole in the base of the bracket, about a half-inch back, centered on the end which does not have the two plates perpendicular to the base. Put a half-inch self-tapping screw through this hole. One can still adjust the angle of the Fuzzbuster, but it remains stationary. It can still be easily removed. As an aside, if you have a rattling noise in your Fuzzbuster, just install a noise suppressor, available for less than $5.Author: Joshua Weinstein
90-92 Bay State Road, Box 72, Boston, Ma 02215


Submit a Comment

Your email address will not be published. Required fields are marked *

Restoration Categories

Updates by Email

BMW 2002 T-shirts

Today’s BMW Poll